Trim the banner on the top and sides leaving 5mm where the windscreen seals are.You can continue to push out the water firmly to apply the rest of the area with the backing paper removed.Tack down the centre by pressing down with your finger before firmly pushing out the water with the Seconds Please! Squeegee in the same area.Make sure all your adjustments are made at this stage before progressing. Spray down the windscreen and vinyl with water thoroughly (More cant hurt).Lift up half the banner on the long side and peel off the backing paper and trim halfway.Use masking tape to keep the banner centred (Align the banner vertically and horizontally, use a ruler for precise measurements) Measure out how you want it to fit, we recommend keeping the logo under the top of the windshield at minimum and above the arrows marked on the windscreen (whatever is legal for your country for sunstrips).Application tape can be removed instantly.Take your time and line it up, tack from trimmed half of backing paper.(Clean but hardest method of application) Remove from largest decal area to thinnest, avoid removing directly towards thin areas. Recommended to leave on application tape as the decal adheres for a few hours before removal.Work slowly and remove as much water as possible taking care not to trap any bubbles. “Tack” centre of decal down firmly and hold with one hand, press down firmly using a card or Squeegee at an angle and work from center out in an arc.Make sure to position it how you want at this stage.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |